Case studies

Delta Registered Installers, Abtech (UK) Ltd were called upon to give assistance on a particularly technically complicated project where approaches to waterproofing design and installation had been incorporated, however the system had failed.  For a great remedial waterproofing outcome, seek assistance from an experienced waterproofing company to inspect your site and carry out the remedial work.

The property when built had a Type C, cavity drain membrane systems incorporated (not a Delta System), however there was no basement drainage incorporated into the design to manage water ingress.

The scope of the works was to design, specify and install a suitable waterproofing solution to 2 large properties engineered from ICF construction which required waterproofing.  Areas where attention from a skilled specialist were required, was to the rear and two side walls which were earth/ground retaining. 

When specifying a suitable waterproofing solution, consideration to the final use of the building, designing a system to be maintainable and repairable along with a deep understanding of BS 8102:2009 is essential in ensuring project success. 

Waterproofing design is a key and critical component for successful construction of below ground structures.  Whether it’s a completely new build or making smaller changes to an existing property, waterproofing design should never be overlooked. 

Waterproofing might account for just a small fraction of a building’s total cost, but waterproofing defects can result in catastrophic consequences.  When waterproofing fails, the implications are significant.

Delta’s MD, Kevin Dodds was approached to offer advice and guidance on a failed waterproofing system.

Delta Registered Installers, Timberwise were called upon to provide a waterproofing solution to a large detached, luxurious new build property in Birmingham.  The impressive, basement extension, was designed to house a cinema room, gym, and wine cellar.

The scope of the project was to facilitate a waterproofing solution for a substantial brick built detached property with a large 3 elevation basement situated at the bottom of a steep sloping driveway.  The basement when constructed had 1 form of external waterproofing incorporated during the build stage, however the system required a second form of internal waterproofing due to the location of the structure and high-water table, capable of protecting the luxurious basement from unwanted water ingress.